Fibreglass Fence Posts and Post Rammer Tools
Kiwitech Plain and unique Arrow Fibreglass Posts contribute to making a super tough, ultra-resilient electric fence line.
No shorting out, rot or rust, quick and simple to install and easy to remove and re-use. All Kiwitech fibreglass is UV paint coated for long life. 10mm posts are perfect for semi-permanent or permanent internal boundary fencing and sub-division projects.
Arrow Fibreglass Posts
The solid plastic barbed head of the Arrow Post makes for an extraordinary electric fencing post. It is stiffer withstanding far greater loads than Plain fibreglass posts and gives terrific hold in the ground. Arrow Posts can be used anywhere and are especially recommended for use on; irregular terrain (crests, dips), dry or flood prone conditions, sand or marsh country and high challenge fence lines (races).

10mm White Arrow Posts
-
FI TA10-1250
Arrow Post White: 10mm*1250mm
(standard length for cattle & sheep) -
FI TA10-1400
Arrow Post White: 10mm*1400mm
Arrow Posts must be planted deep, then pulled back in order to trigger the barbs. Because of their ferocious grip an Arrow Rammer is usually needed for retraction.
Plain Fibreglass Posts
9mm White Posts
Core component of the Kiwitech temporary fencing Tread-in (Standard). Design your own Tread-ins (visit pages ‘Permanent Fencing-Clips’ and ‘Temporary Fencing-Tread-in and Winder Parts’ for Pedals with Pins and Release Hooks).
-
FI P9-1000
Plain White Post: 9mm*1000mm
(standard length for Tread-in use) -
FI P9-1250
Plain White Post: 9mm*1250mm
10mm White Posts
Super quick to install and remove by hand, ideal for semi-permanent or permanent fencing where terrain is flat to gently rolling and fences are under low pressure. Great for dairy farm track fences or semi-permanent paddocks. Very low cost per meter fencing.
-
FI P10-1250
Plain White Post: 10mm*1250mm
(standard length for cattle & sheep) -
FI P10-1500
Plain White Post: 10mm*1500mm
Techno Arrow Post Rammer
Good for virtually any type of fibreglass post (Plain or Arrow) up to 1500mm in length - variable sized spacers in the head adjust for different post lengths. Is a definite requirement for triggering Arrows.
Techno Arrow Post Pilot
Recommended when fencing in hard dry or stony ground to create a pilot hole for the Arrow Post.
Hand-Held Fibreglass Post Rammers (Drivers) and Pilot
These tools were designed for planting 10mm fibreglass posts.
-
FT HAMCAPNY
Nylon Hammer Drive Cap
(for 10mm diameter posts) -
FT RAMSH
Rammer (Driver) Short
(for 1250mm length posts, weighs 3kg) -
FT RAMLG
Rammer (Driver) Long
(for 1500mm length posts, weighs 3.35kg.)